If you’re looking to install an electric tankless water heater, follow this comprehensive 10-step guide for a successful installation:
Turn Off the Circuit Breaker and Water Supply:
– Before starting the project, ensure the circuit breaker is switched off to prevent any accidents.
– Additionally, turn off the water supply to avoid flooding during the installation.
Drain the Old Water Heater:
– Prior to disconnecting the old water heater, drain it completely using a hose and a container.
– Take precautions to avoid damaging the pipes and wiring during the draining process.
Remove the Front Cover:
– Carefully remove the front cover of the tankless unit using a screwdriver.
– Keep track of the screws to avoid losing them and ensure they are properly used during reassembly.
– Unplug any cables attached between the cover and the unit before removing the cover completely.
Mount the Water Heater:
– Choose a suitable wall location for mounting the water heater, ensuring it’s easily accessible and uncluttered.
– Use the included mount and screws to securely mount the unit according to the manufacturer’s instructions.
Connect the Pipes:
– Once the water heater is installed, connect the pipes for hot water distribution in your home.
– Locate the inlet and outlet connections at the bottom of the unit, following the installation guide if provided.
– Stainless steel pipes are recommended for their durability and flexibility. Copper or PVC pipes are acceptable alternatives.
Install Flow and Pressure Valves:
– After making the connections, install flow valves to control water flow to the heater for maintenance purposes.
– Pressure valves may be required by local plumbing regulations. Install them on the “hot-water” side of the electric water heater for safety.
Bleed the Hot Water System:
– Open all hot water outlets in your home to purge any air from the system.
– After a few moments, close the outlets to complete the bleeding process.
Check Electrical Connections Before Attaching the Cover:
– Thoroughly inspect the electrical connections of the water heater to ensure safety.
– Verify that the connections are properly wired and positioned on the correct terminals.
– Reattach the cover securely using all the screws provided.
Switch On the Circuit Breaker:
– With the installation complete, you can safely turn on the circuit breaker.
Test Outlets and Check the Temperature:
– Set the desired temperature for the water heater, avoiding the highest setting to prevent burns.
– Test all hot water outlets in your home, including faucets, showers, and dishwashers.
– Adjust the temperature if needed to ensure the water is at the desired warmth.
By following these steps, you can successfully install your electric tankless water heater and enjoy its benefits.
This post was written by Joey Denick. Joey is the Owner and Operator of Clog Kings. At Clog Kings, LLC, we pride ourselves on our dedication and efficiency. We know you don’t have time to waste. That’s why we work fast to get your home or commercial building back up and running in no time. If you are looking for water heaters in Saint Petersburg FL then look no further because we got you covered!
